Attention Point With Service - Daewoo DWD-1211RT Service Manual

10. ATTENTION POINT WITH SERVICING
No Item
1 Replacing Thermistor Thermistor Dry
Dry
2 Replacing Duct B As DUCT B AS &
& Duct Pipe DUCT PIPE
3 Replacing & Inlet Valve
Repairing Inlet Valve
4 Replacing Hose Drain Hose Drain
5 Replacing HOSE HOSE A,B,C
A,B,C
6 Replacing Heater Wash
Heater Wash the nut for fixing heater
fixture heater can deform)
7 Replacing Thermistor Wash
"Thermistor Wash"
8 Assembling Hinge Door
"Hinge Door"
9 (Dis)assebling Door As
"Door AS"
10 (Dis)assembling MOTOR AS
"Motor AS"
stator and fasten the screw; at unfastening the screw, grip the
stator so that it does not fall.
Part Name
Keep the Packing from seperating (Hold Packing when replacing)
Keep the Packing from folding
Check the sealing between Duct Pipe & Duct B AS
Use only screw M4*8 for fixing Inlet Valve
Keep the sealing condition of Tub O tightly
Check the assembling order between INLET BOX & Hose A,C :
Pre Wash-Cold
Unfastening the nut for fixing earth first then unfasten
At assembling the heater dry, check if the assembling condition between
fixture heater is tight.(little gap on left & right)
fastening the nut for fixing the heater wash, keep the protrusion length of
bolt to 10~12mm.
(if under 10mm, water can leak, and if over 12mm,
Unfasten the Nut for fixing heater, replace the thermistor, and
fasten the nut for fixing heater
At fastening screw for fixing Door AS, be careful so that scratching at
the related parts does not happen
: If the scratching happens, it is possible to be claimed about
appearance damage
Be careful about the up/down direction of Door Glass : Keep the
indication point of the part code downward.
To avoid the injury on the hand, grip the rim of the rotor
At initiating the assembling operation of the stator, grip the
52
Checking Point
At