Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Solwise NET-3G-A10
Summary of Contents for Solwise NET-3G-A10
- Page 1 3G/4G HOTSPOT Quick Start Guide...
- Page 2 1 Introduction 1.1 Check Package Contents 3G Hotspot x1 USB cable x1 1500mAh Lithium (Li-ion) battery x1 Quick Start Guide x1 1.2 Appearance 1.3 LED indicators Name LED Status Indication Power Light Blue light Power is on Purple light Battery power is charging Blue light Battery power is enough or full Battery power is low and need to be...
- Page 3 Red light Signal is weak Red light flashing No UIM card or Network Registering 1time/Sec Blue light flashing Network Mode registered on 3G network, but not dialing 1time/3Sec Light （3G connect） Blue light flashing registered on 3G network and dialing 1time/Sec Blue light always on registered on 3G network and dialed...
- Page 4 battery life. Step3: Power On. Step4: Connect PC though WIFI. Tip：Before connect the hotspot through WIFI, please make sure your PC have WIFI function and WIFI status in “ON” condition.
- Page 5 3 Open Web Management After make sure the wireless connection of the device, please refer to the following steps to set up Step1: Open Web browser, input “http://192.168.169.1” at Address bar, then press “Enter”. Step2: In the following pop-up window, both input “admin” at “User name” bar and “Password”...
- Page 6 Network information： Network signal, the current registering network, Hotspot name, Connection status. ：Network signal ：Hotspot name ：The current registering network ：Disconnected ：Connected Connection Status: Displays the current network’s upload speed and download speed, information of the current flux and total cumulative flux. WIFI Management：...
- Page 7 button, enter the new password, and then click button. WIFI decryption settings: When the Hotspot is encrypted, click the button interface to directly decrypt. Remark: WIFI default encryption method is WPA-PSK, the number of password request is 8-63 bits. If you need to set other encryption methods, Please click the upper right corner of the “Settings”...
- Page 8 You can use a bent paper clip (or similar) to press the reset button for more than 5 seconds.. The Network Mode Light blinks blue for about a second and then the router reboots to defaults. (2) Enter the WEB management by click “settings”, then click the drop-down menu “Admin”, select “Settings”...
Need help?
Do you have a question about the NET-3G-A10 and is the answer not in the manual?
Questions and answers