Physical Functions; Logic Functions; Decoder Functions And Cv Settings - marklin 60975 User Manual

and on the Internet (see Physical Functions for the address).
We recommend that in general programming should be done on
the programming track.

Physical Functions

Each of these functions must be connected externally to the cir-
cuit board. We therefore speak of physical functions. A unique
mode/effect can be assigned to each physical output (AUX /
lights) in digital operation. Four CVs are available for each output
for this purpose. Only one mode/effect can be set for each out-
put. A complete table for this can be found on the Internet at:
www.maerklin.de/de/produkte/tools_downloads/technische_in-
fos.html

Logic Functions

Since these functions are only executed by software, no
physical output is required for them. We therefore speak here of
a logic function.
Acceleration/Braking Delay
• The acceleration and braking time can be set separately from
each other.
• The logic function ABV can be assigned to any function
button by using the function mapping.
Switching Range (RG)
• The switching range causes a reduction in the current speed
of the locomotive. This allows a fine touch in the controlling
the locomotive. The switching range can be assigned in mfx
and DCC to any function button by using the function mapping
(see CV 145, page 45).
Opening Doors / Closing Doors
The locomotive does not start running as long as the function
"opening doors / closing doors" is active. The locomotive starts
accelerating according to the ABV that has been set/activated
only when the function has been deactivated and the sound
has ended.
Station Announcement
The locomotive does not go until after the announcement has
ended.

Decoder functions and CV settings

The following pages have the functions and the CVs presented
in tabular form. These CVs can be given a number of settings
and can be assigned to a number of function buttons.
You'll find the CVs and their applications for the track formats fx
(MM) and DCC in separate tables.
The track format mfx can be easily set by using the display
on the CS 2 with Software Version 2.0 and higher. You or your
dealer may have to install an update on your 60213/60214/60215
Central Station.
33