Factory Default; Configure The Camera's Vigil Connect Alias - 3xLogic V Series Quick Start Manual

7 Factory Default

Resetting the device back to the factory default will reinitialize all parameters including the IP address back to
the factory defaults. To reset back to the factory default:
Steps:
1). Press the reset button and hold it while the device is in use.
2). Release the button after about 10 seconds.
3). Wait for the system to reboot.
NOTE:
Factory Default Connection Settings
IP Address
Network Mask
Gateway
User ID
Password

8 Configure the Camera's VIGIL Connect Alias

VIGIL Connect allows VIGIL VMS users to remotely connect to a VIGIL Server/V-Series All-in-One camera using
the system serial number or a user defined VIGIL Connect alias, without the need for extensive changes to an
existing network's settings. This allows for the device to be networked with other VIGIL suite utilities with little
effort and minimal knowledge of the device's network connection values.
Steps:
1). To configure a VIGIL Connect alias, navigate to the camera's Basic Tab>Camera Configuration Menu>Site
Information Settings page.
2). Fill in the VIGIL Connect Alias field with an alias of your choosing.
3). Click Apply to save the new alias.
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
192.168.XX.YY
255.255.0.0
192.168.0.1
admin
12345
Figure 4-6: Configuring a VIGIL Connect Alias
VISIX Camera Quick Start Guide | VX-2A-B-IWD (R)
9