Mobius Mini ActionCam User Manual page 5

Camera Setup (Configuration)
GUI (Graphical User Interface) configuration - recommended method
On Windows it is recommended to always use the program mSetup.exe to modify the
camera's configuration. mSetup communicates directly with the camera and makes
configuring the camera a very simple task.
The camera must be in Webcam mode in order to set the parameters. See Webcam
Mode, above.
Manual configuration
It is also possible to manually change the configuration settings by using the On
Screen Display (OSD) by connecting the camera to an external Monitor/TV. This
requires a special cable.
1. Disconnect the camera from the PC and turn it off.
2. Connect the camera to an external monitor/TV using the special cable.
3. Optional. You may also connect the USB plug to a power source. The camera
will automatically turn on.
4. Turn on the camera by pressing the Power button until the LEDs begin to blink.
5. Long-press the Shutter button to enter OSD Menu Mode.
6. Briefly press the Shutter button to switch between Recording settings and Basic
settings. Ensure that no parameters are highlighted.
7. Briefly press the Mode button to move down the list or the Power button to move
up the list.
8. Briefly press the Shutter button to change a parameter value.
9. Use the Mode button or the Power button to move down or up the list (see
above).
10. Briefly press the Shutter button to select the value.
11. Long-press the Shutter button to exit OSD Menu Mode and return to Standby
Mode.
► The meaning of the different buttons are shown on the OSD. Up, Down, Enter
► In order to switch between Recording settings and Basic settings make sure no
parameters are selected. Use the appropriate buttons to move the selection up or
down to the top or the bottom of the list.
► Also see OSD (On Screen Display) Menu, below.
Using Software to configure the camera
The Windows program mSetup.exe will automatically configure the camera with the
parameters you require (see above). Detailed instructions can be found in the program
by clicking the "Help" button. The program is also used to synchronize the camera's
internal clock with the computer's date and time.