Mobius Mini ActionCam User Manual page 2

The Reset button
The reset button is in the small hole located below and to the right of the USB Socket
(looking at the camera from the rear). It can be pressed by carefully inserting a bent
paper clip or similar instrument. The Reset button should only be pressed in case the
camera no longer reacts to button presses. Pressing the Reset button will force the
processor to restart. No parameter settings will be lost and the RTC (Real Time Clock)
will not be interrupted. Do not confuse the reset button with the rear LED below and to
the left of the USB socket (looking at the camera from the rear).
The Power button
Press the power button until the LEDs start to blink. After a short while a steady yellow
LED is shown. The camera is now ready for use (standby).
•
To turn off the camera, first stop any recordings that may be running by pressing
the shutter button and then press the power button for about 2 seconds until the
camera turns off.
The Mode button
The Mode button enables the camera to be sequentially switched between 3 (4)
different modes. Each button press advances to the next mode indicated by the LED
color.
•
Video Mode 1 (yellow LED). The frame rate and resolution can be individually
configured.
•
Video Mode 2 (blue LED). The frame rate and resolution can be individually
configured.
•
Photo Mode (red LED) which also includes Time-Lapse photos.
•
Playback Mode (blue LED) only when external monitor (Video-Out/TV-Out)
connected.
The Shutter button
Press the shutter button to start or end a video recording or to take a picture.
LED status indicators
The following LED states are for a camera not connected to the PC.
•
Steady Yellow - The camera is in Video Mode 1 and is on standby.
•
Slowly flashing Yellow (1 sec. On, 1 sec. Off) - The camera is in Video Mode 1
and is recording video. The Video Recording indicator (see configuration) must
be ON for this to work.
•
Steady Blue - The camera is in Video Mode 2 or Playback Mode (if an A/V cable
is connected) and is on standby..
•
Slowly flashing Blue (1 sec. On, 1 sec. Off) - The camera is in Video Mode 2 and
is recording video. The Video Recording indicator (see configuration) must be
ON for this to work.
•
Steady Red - The Camera is in Photo Mode.
•
One Red/Yellow flash - The camera has taken a picture.
•
Steady Green - The battery is charging.
The rear LED
If the camera is configured to show the Recording Indicator, then the rear LED will
normally blink in sequence with the main LED while recording or in standby mode.