Mobius Mini ActionCam User Manual page 3

Connecting the camera to the PC
Make sure a card is inserted and the camera is turned OFF if you want to access the
camera as an external device (disk drive, setup). Always connect the camera directly to
the PC. Do not use a USB hub.
► You cannot record video or photos if the camera is connected to the PC as an
external drive.
Charging
•
Connect one end of the supplied standard USB cable to the camera.
•
Connect the other end to a USB, 5V DC power source (wall charger, PC or
external battery).
•
When the yellow LED turns on, press the Power button for about two seconds
to turn the camera OFF.
When charging, the green LED will be on. It will turn off when the battery is fully
charged.
Charging takes about 2 hours for a fully discharged battery with the camera turned off
and connected to an external USB Charger. Batteries are not covered under warranty. If
charged with under-rated chargers or by using a USB hub without an additional power
supply, expect longer charging times. For optimum results, the charging voltage should
be +5V under load. Only use quality chargers capable of supplying 1000mA (1A) and a
stable voltage of at least 5V. Low quality chargers may not be able to supply enough
current and can lead to premature battery failure or, in the worst case, even destroy the
camera.
A new and fully charged battery will record about 30 minutes of 1080p 60fps videos.
Automatic Power Off from Standby mode
If the camera is in standby mode you must take a picture(s) or start a video recording
within *30 seconds. The camera will automatically turn off after *30 seconds of no
activity.
*This value can be set using the setup program. Automatic Power Off can also disabled.
When the special A/V cable is connected, automatic power-off will be disabled. This
prevents signal loss during fpv use when the standby time times out.
Turn on Camera
Press the Power button until the LEDs begin to blink. The camera is ready for use once
the Yellow LED turns on. .
Turn off Camera
Press and hold the Power Button for about 3 seconds until the LEDs start to flash. The
camera will then turn off.
Switching between modes
The camera can be switched between the different modes by pressing the Mode button.
Each button click advances the camera to the next mode. Video Mode1 - Video Mode2 -
Photo Mode - (*Playback Mode) - Video Mode1 etc.
► *If the camera is connected to an external Monitor/TV the camera will enter Playback
mode (blue LED) after pressing the Mode button when in Photo mode. See OSD (On
Screen Display) Menu below.