Table of Contents
Advertisement
Connect Power
1. Connect the power cable from a power source (typically a
UPS) to the power inlet on the rear panel. The power cable
is included in the appliance packaging.
2. The display will show the System Off message:
Power On/Off the Appliance
Power on and boot the appliance by pressing the Jog Dial.
While it is possible to power off the appliance by pressing the Jog
Dial for 5 seconds, it is far better to use the Shutdown option from
the front panel display menu to power off the appliance gracefully.
The Next Step
Once the appliance is installed on the network, next configure network and appliance information.
Page | 20
E Series Installation Guide
Advertisement
Table of Contents
