Connect The Appliance To The Network - Celestix cloud edge Installation Manual

b. Attach the appliance to the front supports of the equipment rack using a screw (not
provided) for each of the holes on each of the brackets.
The diagram below provides a reference.
Illustration 7: Appliance Mounting Brackets

Connect the Appliance to the Network

Once the appliance is racked, it must be connected to the network.
It is most common that an IP address will be assigned through DHCP, and then configuration for a
static address is covered in the Quick Setup Wizard
the section Configure IP Address without DHCP
adapter.
To connect the appliance
1. Connect an Ethernet cable from the LAN0 network adapter on the Celestix appliance to the
internal network hub or switch.
2. [Optional] For additional network connections, use the LAN1 adapter (or above) on the appli-
ance.
The diagram below provides a reference.
Page | 17
interfaces instructions. If DHCP is not deployed,
explains how to add the IP address to the network
E Series Installation Guide