Panasonic KX-TG5521RUB Service Manual page 54

KX-TG5521RUB/KX-TGA551RUB
11.5.2. How to install Batch file into P.C.
1.
Insert the Batch file CD-ROM into CD-ROM drive and
copy PNZZTG***** folder to your PC (example: D drive).
2.
Open an MS-DOS mode window.
3.
At the DOS prompt, type "D:" (for example) to select the
drive, then press the Enter key.
4.
Type "CD PNZZTG*****", then press the Enter key.
5.
Type "SET RTX_COM=X", then press the Enter key
(X: COM port number used for the serial connection on your PC).
6.
Type "READID", then press the Enter key.
If any error messages appear, change the port number or
check the cable connection.
If any value appear, go to next step.
7.
Type "DOSKEY", then press the Enter key.
Note:
• "*****" varies depending on the country or models.
11.5.3. Commands
See the table below for frequently used commands.
Command name
rdeeprom
readid
writeid
getchk
wreeprom
Function
Read the data of EEPROM
Read ID (RFPI)
Write ID (RFPI)
Read checksum
Write the data of EEPROM
<Example for Windows>
On your computer, click [Start], select Programs
(All Programs for Windows XP/Windows Server 2003),
then click
MS-DOS Prompt. (for Windows 95/Windows 98)
Or
Accessories-MS-DOS Prompt. (for Windows Me)
Or
Command Prompt. (for Windows NT 4.0)
Or
Accessories-Command Prompt.
(for Windows 2000/Windows XP/Windows Server 2003)
<Example>
C: Documents and Settings>D:
D: >CD PNZZTG*****
D: PNZZTG***** >SET RTX_COM=X
D: PNZZTG*****>READID
00 52 4F A8 A8
D: PNZZTG*****>DOSKEY
D: PNZZTG*****>
<Example: Error happens>
C: Documents and Settings>D:
D: >CD PNZZTG*****
D: PNZZTG***** >SET RTX_COM=X
D: PNZZTG*****>READID
CreateFile error
ERROR 10: Can't open serial port
D: PNZZTG*****>
Example
Type "rdeeprom 00 00 FF", and the data from address
"00 00" to "FF" is read out.
Type "readid", and the registered ID is read out.
Type "writeid 00 18 E0 0E 98", and the ID "0018 E0 0E
98" is written.
Type "getchk".
Type "wreeprom 01 23 45". "01 23" is address and "45"
is data to be written.
54