Pittasoft BLACKVUE LCD Quick Manual page 11

Dash cam lcd screen

Hide thumbs Also See for BLACKVUE LCD:

Table of Contents

Available languages

Enlarged version

Organize the cables, using the cable clip, to prevent the driver's vision from

being interrupted.

Start-up of the vehicle, then check if the product is properly operating.

Adjust the camera angle to view the LCD screen. Slightly unfasten the cam-

era angle control bolt to adjust the angle; then fasten the bolt. Even if the

prop is detached, the camera angle can be maintained. Thus, the camera

can be installed at the same lens angle as before.

Caution

y Do not remove the microSD card while it is saving or reading data. This

may cause data damaged or malfunction.

Note

y After a test drive, check if the video has been properly recorded.

y The recorded video is saved in MP4 format.

PLEASE CONNECT REAR CAMERA FIRST BEFORE CONNECT THE POWER

CORD ON FRONT CAMERA.

Table of Contents

Chapters

Table of Contents

Do you have a question about the BLACKVUE LCD and is the answer not in the manual?