Removing The Hose Reel - Kärcher HDS Middle series Service Manual

Basic Settings and Service Procedures

3.7 Removing the hose reel

Undo high-pressure line
4
Rear hose reel shell
8
7
Concealed screws in front half-shell
Page 102 / 127
1
2
3
5
6
HDS Middle Range / HDS Premium Range
3.7.2 Replacing the rotating union seal
(continued)
– Only if necessary: Undo the high-pressure
line (1) using open-end spanner (SW 27) and
remove the two screws in the rear bearing
block (see page 101 Item 10 and 11).
– Re-install the hose reel. Push rear hose reel
shell (3) onto axle, insert connection piece (4)
and install circlip (5). Move hose reel into the
displayed position.
– Insert front hose reel half-shell (6) with crank
(7) and ensure it is correctly positioned.
– Install the two countersunk screws (8).
– Turn hose reel (6) through 180° and install
another countersunk screw (see page 100,
Item 1).
– Install front bearing block with four screws.
– Insert new hose through the hose guide
provided and the deflection pulley on the
underside of the unit.
– Completely push the hose nipple into the
connection piece of the hose reel and secure
with clip (see page 99, Item 3).
– Re-install the second half-shell (see page 99,
Item 1).
1 High-pressure line to the connection
piece
2 Open-ended spanner (SW 27)
3 Hose reel, rear shell
4 Connection piece
5 Axle, hose reel
6 Half-shell, hose reel
7 Crank
Service Manual 04.2008