Impecca ISMI-W092 Manual page 30

Installation of indoor unit
2. Make the power connection cord go
through the cable-cross hole at the back
of indoor unit and then pull it out from
the front side.
3. Remove the wire clip; connect the power connection cord to the wiring terminal
according to the color ;tighten the screws and then fix the power connection cord
with wire clip.
If there is no wired controller in the product you bought ,you should put the wire
fixed by the wire clip inside of the electric box first before connecting the power
connection cord.
4. Put wiring cover back and then tighten the screw.
5. Close the panel.
Note:
All wires of indoor unit and outdoor unit should be connected by a professional.
for a new one. Avoid extending the cord by yourself.
installation.
The air switch should be all-pole parting and the contact parting distance should
be more than 3mm.
power connection
cord
N(1) 2 3
L1 L2
N(1) 2 3
Outdoor unit connection
cord
circuit break must be installed in the line.
27
cable-cross
hole