Impecca ISMI-W092 Manual page 14

Introduction for buttons on remote controller
8
X-FAN button
on remote controller will be displayed. Press this button again to cancel x-fan
Note:
operate at low speed for a while to blow the residual water inside the air duct.
will stop operation immediately.
9
TEMP button
By pressing this button, you can see indoor set temperature, indoor ambient temp-
erature or outdoor ambient temperature on indoor unit's display. The setting on
remote controlleris selected circularly as below:
on indoor unit displays set temperature.
displays indoor ambient temperature.
displays outdoor ambient temperature.
Note:
Outdoor temperature display is not available for some models. At that time, indoor
's defaulted to display set temperature when turning on the unit.There is no
display in the remote controller.
temperature indicator displays corresponding temperature and automatically turn
10
TURBO button
Under COOL or HEAT mode, press this button to turn to quick COOL or quick
HEAT
r.
FAN button to turn of
no display
signal, while it displays indoor set temperature.
11
f, indoor fan will still
r, temperature indicator
r, temperature indicator on indoor unit
r, temperature indicator on indoor unit
y.
r. Press this button again
r.