Medisana 52345 Instruction Manual page 51

4.6.1 Automatically add further SBM devices
4.6.2 Manual adding of further SBM devices
4.6.3 Remove SBM devices
To remove a SBM device, navigate to Settings -> Cameras and tap on the line with the
camera to remove. "Wipe" to the left or to the right to display the button "Delete" and
then tap on "Delete".
4 Operation with Apple device
Navigate to:
Settings -> Find Camera
A list with available SBM devices will be display-
ed. If this is not the case, check the correct
start-up of the device (chapter 3) and tap on
"Find".
Tap on "Add" at the the device to be added -
you will automatically be forwarded to the
set-up of the wireless network. Follow chapter
4.3 Setting up the wireless network.
Navigate to:
Settings -> Cameras -> Camera Setup...
Enter the name (Camera Alias) and the IP ad-
dress of the camera.
Make sure, that port, user and password are
correct.
NOTE
The default settings for user name and
password are printed onto the bottom
of the SBM, e. g. "user name: admin,
password: medisana".
Tap on "Add". You will automatically be forwarded
to the SBM picture (a connection to the SBM will
be established). For an instant configuration of
the wireless network, tap on "Network Configu-
ration". Follow chapter 4.3 Setting up the wireless
network. After rebooting of the device, tap on
"Camera Setup" and "Add".
For a subsequent configuration of the network,
follow chapter 4.3 Setting up the wireless
network.
GB
G
G
G
11
GB