Safety Instructions - Bowens XMS Studio Flash User Manual

Safety Instructions

WARNING - Electrical Shock Hazard - High Voltage!
• This unit should only be connected to a mains socket outlet with a protective
earth connection or to a suitably protected battery/mains inverter.
• Only use Bowens mains cables or extension cables.
• The mains cable and plug is regarded as an emergency disconnect device
and should always be readily accessible so that it can be quickly removed.
• Do not open or disassemble the unit as it operates with a high voltage and
contains capacitors that can remain electrically charged for a considerable
time after the unit is turned off or is disconnected from the mains.
• Always disconnect the unit from the mains and avoid touching the flashtube
or modelling lamp when changing reflectors or fitting an umbrella.
Safety Precautions
• Always study and understand this user guide and accompanying safety
instructions before using this unit.
• Make sure that the Bowens User Guide and Safety Instructions always
accompany this unit.
• Bowens products are intended for professional photographic use only
and should not be used for any other purpose.
• Always remove the protective cap from the unit before use.
• Do not point the unit too close to persons.
• Do not use the modelling lamp if it is damaged or deformed.
• When replacing a modelling lamp avoid touching the bulb with bare hands,
use a clean tissue or cloth.
• Do not touch any hot parts with bare fingers. The modelling lamp, flashtube
and certain metal parts can become very hot. Allow the unit to cool before
touching any user changeable parts.
• Ensure that the modelling lamp voltage and power rating corresponds with
that in the user guide specification. A lamp with a lower rated power may be
safely used but the voltage must always be correct for the power supply
being used.
• Equipment should only be serviced, modified or repaired by authorised and
competent service personnel.
5