Bowens XMS Studio Flash User Manual page 6

Safety Instructions
6
Environmental Safety
• Do not place or use the unit where it could be exposed to moisture, dripping,
splashing, extreme electromagnetic fields or in areas with flammable liquids, gases or dust.
• Do not expose the unit to rapid temperature changes in humid conditions as this can lead to
internal condensation.
• When transporting the unit between cold and warm conditions always allow
the unit to acclimatise for at least two hours before connecting to the mains.
• Do not obstruct the ventilation slots in any way with filters, diffusing materials, etc.
• Do not place any form of material over or close to the glass dome, modelling
lamp or flash tube.
Radio Frequency
This equipment makes use of the radio spectrum for triggering and remote control and therefore receives and emits radio
frequency energy. Ensure that all specifications within this document are followed, especially those concerning operating
temperature and supply voltage range. Make sure that the unit is operated according to local regulations. The frequency
spectrum that this unit uses is shared with other users so interference either with this unit or with other users is possible.
Final Disposal
This unit contains electrical and electronic components that could be harmful to the environment. Follow local legal
requirements for separate disposal of waste, for instance WEEE directive for electrical and electronic equipment on the
European market at the end of the product life.
FCC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
FCCID: 2AI2WXMS
FCC Caution: Changes or modifications not expressly approved by the part responsible for compliance could void
the user's authority to operate the equipment.
FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.