Safety Notes; General Features - Bowens RingflashPro Owner's Handbook Manual

-
safety notes do
• be careful of and avoid placing the
Ringflash cable where it can tripped over.
• switch the pack on AFTER the Ringflash
has been connected.
• ensure that the Ringflash cable connectors
are correctly fitted before using.
• remove the plastic protective before use.
• turn OFF the pack, diconnect from the
power supply, unplug the Ringflash and
allow to cool down before attaching or
removing any accessories or reflectors
.
• use with the protective glass cover
attached.
-
safety notes do not
• place heavy objects on top of the Ringflash
cables and avoid running them over sharp
or hot objects.
• use the equipment with damaged cables.
Have them replaced as soon as possible.
NEVER attempt to repair them yourself.
• use in an environment where moisture,
water vapour or inflammable liquids,
vapour or materials may come into contact
with the Ringflash or pack.
The flash output as well as modelling
lamps can cause ignition of or damage to
materials that may come into contact with
the Ringflash.
• obstruct the airflow around the Ringflash
or pack.
general features
• Flash tubes with colour corrective UV
coating.
• Adjustable modelling lamps with On/Off
switch.
• Easy fitting of reflectors and accessories.
• Universal camera bracket.
• Can be used with light stand or camera
stand.
• Incorporates handle for portable hand held
use.
• Includes built-in thermal cut out. The cut
out will only stop the Ringflash from
flashing. If this occurs it is advised to
turn off the modelling and allow to cool
for 10 minutes. Do not turn off the pack as
the Ringflash fans will aid and speed up
the cooling process.