Table of Contents
Advertisement
Operation
10
Flash Output Setting
Use the Rotary Control to change the flash output level.
1.
The current flash energy is shown on the digital display in digital f-stops. All
flash settings are related to the max setting (100%) which is shown as 10.
2.
Turn the Rotary Control clockwise to increase the energy level in 1/10 f-stop
increments, and counter-clockwise to decrease. Press and hold down
the Rotary Control while turning to increase or decrease the setting in 1 f-stop
increments.
F-STOP
SETTING
10
9.0
8.0
7.0
6.0
5.0
4.0
3.0
Modelling Light Mode Setting
Use the LAMP button to select the modelling light:
1.
To select proportional modelling, press and hold down the LAMP button
until the PROP Indicator is illuminated. The modelling light intensity
automatically adjusts to correspond to the flash energy level.
2.
To select Free modelling, press and hold down the LAMP button until the
FREE Indicator is illuminated. The last pre-set brightness level of Free
modelling will be used.
3.
To turn off the modelling light, briefly press the LAMP button. Both the
indicators will be turned off.
4.
Briefly press the LAMP button again to turn the modelling light back on.
Modelling Light Free Setting
To change the level of the FREE modelling light:
1.
Press and hold the LAMP button until the FREE indicator flashes (FREE
set mode).
2.
While the indicator is flashing the display will alternately show LF and the
current FREE value. This will timeout after 8 seconds and revert to FREE.
FRACTIONAL
ENERGY
-
1/1
-
1/2
-
1/4
-
1/8
-
1/16
-
1/32
-
1/64
-
1/128
Hide quick links:
Advertisement
Table of Contents
