Radio Fault; Errors - Bowens XMS Studio Flash User Manual

Warnings
24
OH indication continued:
CONDITION
Flash rate excessively fast:
Fan not running or slow:
OH does not clear:

Radio Fault

If there is a fault with the radio system then the RADIO LED will blink when the radio sync
source is selected. Normally, the unit can still be used with this fault by using one of the
other sync sources. If the fault does not clear after switching off and on again then the
unit needs to be serviced by an authorised repairer.

Errors

Errors are due to an internal fault that either cannot be cleared or re-occurs frequently.
This includes the fan not running when OH is displayed.
An Error displayed will require the unit to be checked and repaired by an authorised
repairer. Failure to take steps to correct the error or having the repair carried out by an
unauthorised repairer will invalidate the warranty.
DISPLAY
E1
E2
E3
E4
E5
NOTE: Due to the capacitor charging system used, the XMS can make a slight audible
ticking at rest or when charging. This is completely normal and can be regarded as a sign
of correct operation.
STEPS TO RECTIFY
Reduce the flash rate and/or only flash at a fast
rate in blocks with longer cooling periods in
between.
Unit requires repair.
Unit requires repair.
DESCRIPTION
Open temperature sensor
Shorted temperature sensor
Failed to auto- dump
Failed to charge
Over voltage detected
POSSIBLE SOLUTION
Requires repair if persistent.
Requires repair if persistent.
Requires repair if persistent.
Requires repair if persistent.
Requires repair if persistent.