Defining Line Fields; About Line Fields - Paxar Monarch DOS-based Pathfinder Ultra System 6035 User Manual

D E F I N I N G L I N E F I E L D S
Use lines to form borders or mark out original prices. Define each
line separately.
NOTE: This field is not assigned a field number, but is counted as a field
(keep this in mind, as the printer allows a maximum of 50 fields per
format).
You can define any line length and a thickness up to 10 dots, as long as the
solid black print does not exceed 30% of any given square inch of the label.
Data edits do not apply to line fields.
NOTE: All samples shown in this chapter are created using 2.0-inch long by
2.0-inch wide supplies.
A b o u t L i n e F i e l d s
Read the following information to become familiar with the prompts for line
fields. Valid ranges for the prompts are listed as well as information about
using line fields.
Format Name
Format Number
Format
Description
Supply Length
Supply Width
Field Type
Depending on your printer's configuration, enter a name for
the format. For more information about your printer's
configuration, see Chapter 3, "Configuring the Printer." The
maximum number of characters for the format name is 16.
Reserved for future use. (Depending on your printer's
configuration, enter a number for the format. The format
number range is 1 – 99.)
Reserved for future use. (Depending on your printer's
configuration, enter a description for the format.)
The length of your loaded supply. Measure from the top of
one black mark to the top of the next black mark. The
standard supply lengths are: 55, 78, 110, 150, 200, 300, or
400 inches.
The width of your loaded supply. Choices include 1.20, 1.50,
or 2.00 inches.
Choices include text, bar code, constant text, and line.
8

Defining Line Fields 8-1