IBM ThinkPad T40 series Hardware Maintenance Manual page 63

Symptom or error
1810
Hard disk partition layout error.
2000
IBM Hard Drive Active
Protection sensor diagnostics
failed.
Press <Esc> to continue.
Press <F1> to enter SETUP
FRU or action, in sequence
1. If the Access IBM
2. If the Access IBM
3. If item 2 failed, press F3 in
4. If item 3 failed, select
5. If item 4 failed, replace the
1. Undock docking station or
2. Run Diagnostics --> Other
ThinkPad T40, T40p, T41 Series
Symptom-to-FRU index
Predesktop Area has been
previously disabled, then
go to the IBM BIOS Setup
Utility by pressing F1 to
open the IBM BIOS Setup
Utility. Select Security -->
IBM Predesktop Area -->
Access IBM Predesktop
Area. Set this item to
Disabled. Save and exit.
Predesktop Area has not
been previously disabled,
press Enter to load Access
IBM Predesktop Area. Then
run RECOVER TO
FACTORY CONTENTS in
Access IBM Predesktop
Area.
the Welcome screen in
RECOVER TO FACTORY
CONTENTS. Run FDISK,
and then delete all
partitions. Run RECOVER
TO FACTORY CONTENTS
in Access IBM Predesktop
Area again.
CD-ROM boot in Startup in
Access IBM Predesktop
Area. Boot from the
Recovery CD and perform
full recovery from it.
hard disk drive.
port replicator if it is
attached to the ThinkPad
computer, and place the
computer on a horizontal
surface. Do not apply any
physical shock to the
computer.
Devices --> IBM HDD
Active Protection Test.
59