IDEAL 3915-95 Operating Instructions Manual page 27

•
Blade and cutting stick replacement
3.
4.
OK
Clamping Blade
OK
•
1.
2.
5.
A
2.
1.
Close the safety guard (1.) Lower the blade by
pressing both cutting buttons (2.). Keep one
button pressed and turn off the main switch (3.).
Open the safety guard (4.). With the special
wrench (B) the 3 eccentrics shall be screwed
so far down (5.)until the paper is cut along the
entire length of the blade (The blade must
remain parallel, not too deep into cutting stick).
Turn main switch to position I. (1.) The blade
will return to the upper position and the blade
screws should be tightened firmly (2.).
Danger! Do not turn main switch to position
"0" whilst blade is moving upwards! The clamp
must always overlap the blade!
Risk of injury!
- 27 -