To Increase Cruising Speed; To Increase Speed Using Cruise Control Switch; To Increase Speed Using Accelerator Pedal - Mazda CX-3 Owner's Manual

When Driving
Cruise Control
3. Set the cruise control by pressing the
SET or SET
speed. The cruise control is set at the
moment the SET
pressed. Release the accelerator pedal
simultaneously. The cruise set indicator
light (Green) illuminates.
NOTE
The cruise control speed setting
cannot be performed under the
following conditions:
(Automatic transaxle)
The selector lever is in the P or N
position.
(Manual transaxle)
The shift lever is in the neutral
position.
The parking brake is applied.
(Vehicles with adjustable speed
limiter)
The ON/OFF switch for the
adjustable speed limiter is pressed.
Release the SET
at the desired speed, otherwise the
speed will continue increasing while
the SET switch is pressed and
held, and continue decreasing while
the SET switch is pressed and held
(except when the accelerator pedal is
depressed).
On a steep grade, the vehicle may
momentarily slow down while
ascending, or speed up while
descending.
4–160
switch at the desired
or SET switch is
or SET switch
NOTE
Cruise control will cancel if the
vehicle speed decreases below
21 km/h (13 mph) when cruise is
activated, such as when climbing a
steep grade.
Cruise control may cancel at about
15 km/h (9 mph) below the preset
speed (such as may happen when
climbing a long, steep grade).

To Increase Cruising Speed

Follow either of these procedures.
To increase speed using cruise control
switch
Press the SET switch and hold it. Your
vehicle will accelerate. Release the switch
at the speed you want.
Press the SET switch and release it
immediately to adjust the preset speed.
Multiple operations will increase the
preset speed according to the number of
times it is operated.
Increasing speed with a single SET
switch operation
Meter display for vehicle speed indicated
in km/h: 1 km/h (0.6 mph)
Meter display for vehicle speed indicated
in mph: 1 mph (1.6 km/h)
To increase speed using accelerator
pedal
Depress the accelerator pedal to accelerate
to the desired speed. Press the SET
SET switch and release it immediately.
or