Technical Data; Intended Use - Bosch ake 30 s Original Instruction

F 016 L70 540.book Seite 3 Freitag, 12. Februar 2010 11:19 11
Kickback is the result of tool misuse and/or incorrect
operating procedures or conditions and can be
avoided by taking proper precautions as given be-
low:
Maintain a firm grip, with thumbs and fingers
encircling the chain saw handles, with both
hands on the saw and position your body and
arm to allow you to resist kickback forces.
Kickback forces can be controlled by the opera-
tor, if proper precautions are taken. Do not let go
of the chain saw.
Do not over reach and do not cut above shoul-
der height. This helps prevent unintended tip
contact and enables better control of the chain
saw in unexpected situations.
Only use replacement bars and chains speci-
fied by the manufacturer. Incorrect replacement
bars and chains may cause chain breakage and/
or kickback.
Follow the manufacturer's sharpening and
maintenance instructions for the saw chain.
Decreasing the depth gauge height can lead to in-
creased kickback.

Technical data

Chain saw
Part number (typ)
Rated power
Chain speed (no load)
Chain bar length
Tool-less chain tensioning (SDS)
Nose sprocket
Kickback Brake
Chain type
Drive link thickness
Amount of drive links
Oil reservoir capacity
Automatic oiler
Metal gripping teeth
Weight without mains cable. approx. **
Protection class
**measured with chain bar and chain
Note: Please observe the order number of your machine. The trade names of individual machines can vary.
Inrush currents cause short-time voltage drops. Under unfavourable power supply conditions, other equipment may be af-
fected. If the system impedance of the power supply is lower than 0.25 Ohm, disturbances are unlikely to occur.

Intended Use

The chain saw is intended for sawing of trees, tree
trunks, branches, wooden beams, planks, etc. Cuts
can be sawed with or across the grain. This product
is not suitable for sawing mineral materials.
20 • F 016 L70 540 • 10.02
Additional safety warnings:
It is recommended that the first time user should
have practical instruction in the use of the chain-
saw and the protective equipment from an expe-
rienced operator and that the initial practice
should be cutting logs on a saw horse or cradle.
This appliance is not intended for used by per-
sons (including children) with reduced physical,
sensory or mental capabilities, or lack of experi-
ence and knowledge, unless they have been
given supervision or instruction concerning use of
the appliance by a person responsible for their
safety.
Children should be supervised to ensure that they
do not play with the appliance.
Children and juveniles, except above age 16,
under supervision and for educational pur-
poses, must not operate the chain saw, nor
should persons unfamiliar with the saw or its
handling (when borrowing). Ensure operation
manual is with the saw. Persons unfit or tired
must not operate the chain saw.
AKE 30 S AKE 35 S
3 600 H34 4.. 3 600 H34 5..
[W] 1800 1800
[m/s] 9 9
[cm] 30 35
–
3/8" - 90 3/8" - 90
[mm] 1.1 (0.043") 1.1 (0.043")
45 52
[ml] 200 200
[kg] 3.9 4.0
/ II
Introduction
This manual gives instructions on the correct as-
sembly and safe use of your chain saw. It is impor-
tant that you read these instructions carefully.
English - 3
AKE 40 S
3 600 H34 6..
1800
9
40
3/8" - 90
1.1 (0.043")
57
200
4.1
/ II / II