Table of Contents
Advertisement
OBJ_BUCH-1373-002.book Page 19 Thursday, February 10, 2011 10:32 AM
25 Clamping flange
26 Washer
27 Hexagon bolt
28 Tool arm
29 Lock nut of the depth stop
Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Technical Data
Cut off grinder
Article number
Rated power input
No-load speed
min
Weight according to
EPTA-Procedure
01/2003
Protection class
Permissible workpiece dimensions (maximal/minimal)
see page 22.
Starting cycles generate brief voltage drops. Interfer-
ence with other equipment/machines may occur in
case of unfavourable mains system conditions. Mal-
functions are not to be expected for system impedanc-
es below 0,15 ohm.
The values given are valid for a nominal voltage [U] of
230 V. For different voltages and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dimensions of suitable cutting discs
Cutting disc diameter, max.
Cutting discs width, max.
Mounting hole diameter
Bosch Power Tools
Assembly
Delivery Scope
Carefully remove all parts included in the deliv-
ery from their packaging.
Remove all packaging material from the machine
and the accessories provided.
Before starting the operation of the machine for
TCO 2000
the first time, check if all parts listed below have
Professional
been supplied:
3 601 M17 380
– Cut-off grinder with mounted cutting disc
W
2000
– Ring spanner 13
-1
3500
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
kg
15.5
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
/II
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Stationary or Flexible Mounting
Mounting to a Working Surface (see figure A)
– Fasten the power tool with suitable screw
mm
355
mm
3
Flexible Mounting (not recommended!)
mm
25.4
In the exceptional case that it should not be pos-
sible to firmly bench-mount the power tool, you
can provisionally place the legs of base plate 12
on a suitable surface (e. g. a workbench, level
floor, etc.) without bolting the machine down.
Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.
To ensure safe handling, the machine must
be mounted on a level and stable surface
(e. g., workbench) prior to using.
fasteners to the working surface. The mount-
ing holes 9 serve for this purpose.
1 609 929 X93 | (10.2.11)
English | 19
Advertisement
Table of Contents
