Technical Specifications - AEG BSS 4823 Instruction Manual

Memory card slot (6)
1. Use the INPUT button (10) to select SD CARD mode.
2. Insert the memory card with the contacts facing up into
the appropriate slot. Playback will start after a few sec-
onds. The AUX indicator lamp flashes during playback.
For operation of the device, please refer to chapter "Descrip-
tion of the Controls".
CAUTION:
Select another operating mode before removing the
memory card.
Description of the controls
NOTE:
Depending on your playback unit, not all functions might
be supported.
(7)
You can pause and continue music playback. Press again to
continue playback.
(9)
Press 1 x = Restart of the song from the beginning. (Not
during USB/CARD mode)
Press 2 x = Skip to the previous song.
Press 3 x = Skip to the song before the previous song.
(8)
Press to skip to the next song and the following songs.
Cleaning
CAUTION:
Do not submerge the device in water.
• Before cleaning disconnect from mains power supply.
• Clean the device with a soft damp cloth without deter-
gents.
Troubleshooting
Fault Cause
Unit cannot Unit crashes and
be operated. "hangs".

Technical Specifications

Model: .................................................................................BSS 4823
Power supply: ......................................................... AC 230 V, 50 Hz
Power Consumption:..............................................................100 W
Battery: ................................................................... 12 V 12000 mAh
Protection class: ................................................................................II
Net weight: .................................................................approx. 17 kg
Solution
Disconnect from the Microphones
mains for around
Voltage supply: ...............................................2x 1.5 V type AA/R6
5 seconds. Then
Transmission frequency: ..................................636-865 MHz, UHF
switch the unit on
Channels: ...........................................................................................2
again. Power: ......................................................................................50 mW
Bluetooth
Bluetooth support: ........................................................V2.1 + EDR
Range: ..................................................................approx. 15 metres
Transmission frequency: ......................................2.402-2.480 GHz
Protocols: ....................................................................A2DP/AVRCP
Fault Cause
No audio Speaker is not paired
signal via the to the audio source.
Bluetooth
connection
Volume too low
Speaker Pairing does not
cannot be work
connected
Audio source is
switched off
Bluetooth is switched
off at the audio
source.
Bluetooth version is
not supported.
Sharp Audio feedback
whistling
sound during
microphone
operation.
Battery cannot The battery has
be recharged. been discharged
completely.
No sound in Input level too low.
all operating
modes.
................................................................ DC 12 V/5 A
Charging time: ............................................. approx. 11 hours.
Operating time: ................................................up to 36 hours.
English
39
Solution
Check whether a
connection exists. If
necessary, pair the
speaker again to the
audio source.
Increase the volume
on the speaker.
Increase the volume
on the audio source.
Check whether the
audio source supports
the A2DP protocol.
Switch on the audio
source.
Switch on the Blue-
tooth function in the
audio source.
Use a different play-
back unit.
Use the microphones
outside of the
speaker' s reverbera-
tion distance.
Charge the battery
using the DC-12 V IN
input (18).
Press and hold  but-
ton (8) to increase the
input level.