Battery Operation - AEG BSS 4823 Instruction Manual

English
36
Side
17 USB CHARGING port
18 DC-12 V IN input
19 AC/DC POWER mains switch
a DC ON (12 V operation)
b OFF (Off)
c AC ON (mains operation)
20 AC INPUT mains cable connector
Carrying handles (not shown)
Rear (not shown)
Extendable handle
Delivery scope (not shown)
2x Microphone
1x 12 V car adapter cable
1x Mains cable
First Use of the Device/Introduction
• Select a proper place for the device. A dry, level, and slip
proof surface is suitable.
• Make sure the device is ventilated sufficiently!
• Remove the protective film from the device, if present.
Power supply
1. Make sure the grid voltage corresponds to the specifica-
tions on the rating plate.
2. Connect the provided mains cable to the AC INPUT con-
nector (20) on the side of the device.
3. Insert the mains plug to a properly installed socket.
4. Set the mains switch to "AC ON" position (19c).
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Operation via 12 V car adapter
The 12 V cigarette lighter adapter is suitable for cars that
feature a 12 V power supply with negative grounding.
1. Connect the provided car adapter cable to the DC-12 V
IN input (18) on the side of the device.
2. Connect the other end of the cable to the cigarette
lighter receptacle in your car.
3. Set the mains switch to "DC ON" position (19a).
4. Disconnect the 12 V adapter from the device and ciga-
rette lighter receptacle after use.
CAUTION:
• Only use the car adapter cable provided.
• Use the provided car adapter cable for this device only.
Do not use for other devices.
• Do not use the device while driving. Make sure the
device is securely attached or stored away in order not
to fall inside the vehicle in case of an accident.
USB CHARGING port (17)
Use the port on the side of the device to charge your smart-
phone. When operated via mains cable, the device supplies
5 V/1 A. Use the USB cable of your smartphone for the con-
nection.
NOTE:
• Due to the variety of smartphone types available and
their different charging capacity, the charging time
depends on the smartphone used and its operating
condition.
• This port is not suitable for playing audio files.

Battery operation

It is possible to operate this device with the built-in battery.
General information
• Charge the battery completely before you use it to oper-
ate the device.
• Avoid fully discharging the battery.
• Charge the battery completely after each use.
• When the BAT indicator lamp (1) starts flashing, the bat-
tery must be recharged.
Charging the battery
1. Connect the mains cable provided to the AC INPUT con-
nector (20) on the side of the device.
2. Connect the mains plug to a properly installed socket.
3. Set the mains switch to "AC ON" position (19c).
Depending on the battery' s capacity charging can take up to
11 hours.
CAUTION:
Never leave the device unattended during charging.
NOTE:
• The battery can only be charged when the speaker is
switched on.
• If you do not use the device for a longer period of time,
you should charge the battery at least once every 3
months. Even when switched off, the battery discharges
continuously.
• When the battery is almost empty, the BAT indicator
lamp will start flashing. The battery requires recharging.
• If the battery has been discharged completely, the
device cannot be recharged via mains socket. In such a
case, recharge the battery using the DC-12 V IN input
(18). Even when switched off (mains switch at OFF posi-
tion) the battery can be charged via this input.
Operation
AC/DC POWER mains switch (19)
Use the switch to select one of the following operating
modes: