Table of Contents
Advertisement
5.3 TEST MODES
The Model 1140ARC offers two V.54 test modes and two V.52 test
modes to evaluate the condition of the modems and the communication
link. Both sets of tests can be activated physically from the front panel.
The V.54 test can also be activated from the RS-232 interface. Note:
V.54 and V.52 test modes on the Model 1140ARC are available for
point-to-point applications only.
5.3.1 LOCAL ANALOG LOOPBACK (LAL)
The Local Analog Loopback (LAL) test checks the operation of the
local Model 1140ARC, and is performed separately on each unit. Any
data sent to the local Model 1140ARC in this test mode will be echoed
(returned) back to the user device. For example, characters typed on
the keyboard of a terminal will appear on the terminal screen. To
perform a LAL test, follow these steps:
1.
Activate LAL. This may be done in one of two ways: First, by
moving the upper front panel toggle switch RIGHT to "Analog".
Second, by raising pin 18 on the RS-232 interface (note: be
sure DIP switch S2-8 is off). Once LAL is activated, the Model
1140ARC transmit output is connected to its own receiver.
The "Test" LED should be lit.
2.
Verify that the data terminal equipment is operating properly
and can be used for a test.
3.
Locate the lower of the two toggle switches on the front panel
of the Model 1140ARC and move it to the right. This will
activate the V.52 BER test mode and inject a "511" test pattern
into the local loop. If any errors are present in the loop, the
red "Error" LED will blink sporadically.
4.
If the BER test indicates no errors are present, move the V.52
toggle switch to the left, thus activating the "511/E" test with
periodic errors. If the test is working properly, the red "Error"
LED will light. A successful "511/E" test will confirm that the
loop is in place, and that the Model 1140ARC's built-in "511"
generator and detector are working properly.
5.
If the BER test indicates that errors are present, check to see
that the RS-232 cable connecting the DTE to the Model
1140ARC is wired straight through, and is plugged in properly.
Also, ensure that the Model 1140ARC is configured properly.
Then re-check your DTE equipment. If you still have errors,
call Patton Technical Support at (301) 975-1007.
15
Advertisement
Table of Contents
