Installation Area - Bosch Maxx 1000 Instruction Manual

Installation area

Built under or
built in appliance
installation
Downloaded from www.Manualslib.com
Appliance stability is important so that the washing
machine does not "wander" during the spin cycles.
The installation area must be solid and even. Soft floor
surfaces, such as carpets or surfaces with foam bak
king, are not suitable.
If the washing machine is to be installed on a wood
joist ceiling:
1. If possible, place the washing machine in a corner
2. Screw a water resistant wooden board (at least
3. Affix the feet of the washing machine using holding
If the washing machine is to be placed on a pedestal:
4. Affix the feet of the washing machine using holding
*
The appliance must be built under or built in prior to
connecting the power supply.
The appliance can be built into or under a kitchen
work surface. For this purpose, a recess width of
60 cm is required.
q The washing machine must only be installed under
Caution
For safety reasons in built under installation, a metal
cover* must be assembled by a specialist in place of
the appliance cover plate.
*
manuals search engine
of the room.
30 mm thick) to the floor.
brackets*.
brackets*.
Holding brackets (set) can be obtained from
a specialist store or the Customer Service
(order no. WMZ 2200.
a one piece worktop that is permanently attached
to the surrounding cabinets.
The metal cover (set) can be obtained from
a specialist store or the Customer Service
(order no. WMZ 2390).
39