Bosch Maxx 1000 Instruction Manual page 33

Fault
Programme does not
start.
The Ready indicator light
flashes.
Programme does not
start.
Water does enter the
machine or detergent is machine or detergent is
not washed away.
The Active indicator light The Active indicator light
flashes.
Detergent in chamber I is
not washed away.
Water cannot be seen in
drum.
Washing solution is not g
completely drained. l l d i d
The End indicator light
flashes.
Water is flowing out from
underneath the machine.
Foam coming out of the
detergent dispenser.
The laundry was not
spun.
Downloaded from www.Manualslib.com
Cause
Loading door not closed properly.
Start button not pressed.
Water tap not turned on.
Supply hose kinked or trapped.
Strainers in supply hose clogged.
A programme without Prewash was
selected.
This is not a fault.
The water lies below the visible part of the drum.
Loose debris is blocking the pump.
Fluff producing laundry was
washed. The water drainage pipe or
drain hose is blocked.
The thread of the supply hose is not
tight.
Leak in the drain hose.
To much detergent.
Large items of clothing became
entangled and could not be
distributed evenly in the drum.
For safety reasons, the high speed
final spin cycle was automatically
cancelled.
manuals search engine
Action
Check whether laundry is trapped in
door.
Close the loading door (a click
should be heard).
Press the Start button.
Turn on water tap.
Eliminate the cause.
Clean the strainers; see Page 30.
Select 60 °C Cottons+Linens
+ Prewash.
Clean the pump (refer to page 29).
Clean the water drainage pipe
and/or drain hose.
Tighten the thread.
Replace the drain hose.
Mix 1 tablespoon of fabric softener
with ½ litre / 1 pt of water and pour
into chamber II of the detergent dis
penser.
Reduce the amount of detergent
next time.
Always load large and small items
together into the drum (see also
imbalance compensation system).
33