Related Manuals for Bosch Maxx4 WFC1600
Summary of Contents for Bosch Maxx4 WFC1600
- Page 1 All manuals and user guides at all-guides.com Maxx4 WFC1600 en Instruction Manual and Installation Instructions Internet: http://www. bosch-hausgeraete.de...
-
Page 2: Table Of Contents
All manuals and user guides at all-guides.com Table of Contents Safety Instructions ......Operating Before Using Your Washing Machine Instructions For the First Time . -
Page 3: Safety Instructions
All manuals and user guides at all-guides.com Please read this instruction manual and all other infor mation accompanying the washing machine before operating the appliance. Please retain all documents for future reference or for a subsequent appliance owner. Safety Instructions Your washing machine is intended: General - For domestic use only. - Page 4 All manuals and user guides at all-guides.com Control panel 1. Select a programme Can be turned in both directions. Switches on / off the washing machine. The programme selector cannot be turned when the programme is in progress. The programme sequence is controlled electronically.
-
Page 5: Before Using Your Washing Machine For The First Time
All manuals and user guides at all-guides.com Before Using Your Washing Machine For the First Time The washing machine must have been installed and connected properly (refer to Page 22). Your appliance was tested before leaving the factory. To remove any water left over from testing procedures, the first washing cycle should be carried out without laundry in the machine. -
Page 6: Preparing, Sorting And Loading The Laundry
All manuals and user guides at all-guides.com Preparing, Sorting and Loading the Laundry Caution Preparing Loose debris (e.g. coins, paper clips, needles, nails) the laundry can damage items of clothing as well as parts of the washing machine (e.g. drum). q Empty all pockets on items of clothing. -
Page 7: Laundry Detergents And Additives
All manuals and user guides at all-guides.com d Risk of explosion! Loading the laundry Items of clothing that have been pretreated with solvent based cleaning agents, e.g. stain remover and dry cleaning spirit, represent an explosion hazard once loaded into the washing machine. Therefore, these items must first be rinsed thoroughly by hand. -
Page 8: Selecting Programmes
All manuals and user guides at all-guides.com Chamber I: Filling laundry Detergent for prewash or starch. detergent and/or Chamber II: additive dispensers Detergent for main wash, water softener, bleach, pre soaking agent or stain removal product. Chamber 2: Additives, e.g. fabric softener or former. - Fill at least to lower edge of insert 1. - Page 9 All manuals and user guides at all-guides.com 30, 40, 60 C Easy care For easy care fabrics made from cotton, synthetics or blended fibres. 30 C Delicates For sensitive, easy care fabrics made from cotton, synthetics , silk or blended fibres, and net curtains. No spinning between rinsing cycles.
- Page 10 All manuals and user guides at all-guides.com Additional function Basic setting (Spin speed selector pointing upward) In the Cottons + Linens", Easy care" and Wool" programmes the fabrics will be spun at the maximum possible spin speed. In the Delicates"...
-
Page 11: Washing
All manuals and user guides at all-guides.com Washing q Turn on the water tap. Start the q Turn the programme selector to the desired programme programme (refer also to separate Programme Chart"). The Ready" control light comes on. q Where required, press the option button(s) for additional function(s). -
Page 12: When The Programme Has Ended
All manuals and user guides at all-guides.com When the Programme has Ended The End" control light comes on. q Turn the programme selector to Off", and, where required: q Select a programme option ( Drain", Spin" or r Rinse"). q Press the Start"... -
Page 13: Special Applications
All manuals and user guides at all-guides.com Special Applications q Load laundry of the same colour. Pre soak q Add the presoak agent to chamber II according to the manufacturer's specifications. q Turn the programme selector to 30 C Cottons + Linens". -
Page 14: Cleaning And Care
All manuals and user guides at all-guides.com Cleaning and Care d Risk of electric shock! Always disconnect the appliance from the mains before cleaning. Never clean the washing machine with a jet of water. d Risk of explosion! Never use solvents to clean the appliance. As required: Cleaning the q Use hot soapy water or a mild, non abrasive... - Page 15 All manuals and user guides at all-guides.com In the event that residual detergents or additives have Cleaning the accumulated: detergent dispenser q Pull out the detergent dispenser up to the end stop, press down the hollow on the insert and remove the detergent dispenser completely.
- Page 16 All manuals and user guides at all-guides.com This is necessary if the washing solution cannot be Cleaning the drain completely drained. The pump is blocked by either pump loose debris or fluff which accumulates if fluff giving fabrics are washed at high temperatures. Draining the washing (Up to 20 litres / 4.4 gal.
- Page 17 All manuals and user guides at all-guides.com This is necessary if very little or no water flows into the Cleaning water inlet washing machine. strainers First release the water pressure in the supply hose: q Turn off the water tap. q Turn the programme selector to any programme (except Spin"...
-
Page 18: Troubleshooting Minor Faults
All manuals and user guides at all-guides.com Troubleshooting Minor Faults d Risk of electric shock! Repairs must only be carried out by our Customer Service or an authorized technician. If repairs are needed, and assuming that you cannot eliminate the fault yourself with the aid the following table: q Turn the programme selector to Off". - Page 19 All manuals and user guides at all-guides.com Fault Cause Action Programme does not Start" button not pressed. Press the Start" button. start. Water tap not turned on. Turn on water tap. Water does enter the machine or detergent is Supply hose kinked or trapped.
-
Page 20: Customer Service
All manuals and user guides at all-guides.com Fault Cause Action Repeated spinning at This is not a fault. short intervals. The imbalance compensation system is attempting to balance the load through repeated spins. The degree of dirt was higher than Select a more suitable programme. -
Page 21: Consumption Rates
All manuals and user guides at all-guides.com Consumption Rates Normal programme Load Consumption rates ** (without additional (without additional Electricity Water Duration functions) 40 C Cottons + Linens 3.5 kg * 45 l 120 min. 3.0 kg 0.45 kWh 43 l 120 min. -
Page 22: Installation, Connection And Transport
All manuals and user guides at all-guides.com Installation, Connection and Transport d Risk of injury! Safety information The washing machine is heavy. Take care when lifting it. Caution Frozen hoses can tear / burst. Do not install the washing machine outdoors or in an area prone to frost. - Page 23 All manuals and user guides at all-guides.com On the back of the machine: - Water drain hose. - Power cord. Depending on the type of connection, the following may also be required: - 1 hose band clip of 24 40 mm dia. (from specialist store) for connection to a siphon.
- Page 24 All manuals and user guides at all-guides.com Appliance stability is important so that the washing Installation area machine does not wander" during the spin cycles. The installation area must be solid and even. Soft floor surfaces, such as carpets or surfaces with foam backing, are not suitable.
- Page 25 All manuals and user guides at all-guides.com Caution Removing the The transport bolts must always be removed before transport bolts using the appliance for the first time and must be retained for any subsequent transport (e.g. when moving). q Loosen all four transit bolts with the A/F 13 wrench until they are freely movable.
- Page 26 All manuals and user guides at all-guides.com Hose and cable lengths Left hand connection Right hand connection Other hoses Available from specialist dealers: - Extended supply hose (approx. 2.20 m).
- Page 27 All manuals and user guides at all-guides.com Water connection Water supply Caution The washing machine must only be operated with cold tap water. Do not connect the appliance to the mixer tap of an unpressurized hot water boiler. If in any doubt, have the water connection carried out by an authorized technician.
- Page 28 All manuals and user guides at all-guides.com Water drainage Caution Do not bend or pull the water drainage hose. Height difference between the placement area and drainage point: Minimum 60 cm, maximum 100 cm. Drainage into a siphon: q Secure the connection point with a hose band clip of 24 40 mm dia.
- Page 29 All manuals and user guides at all-guides.com Caution Electrical The washing machine must only be connected to connection alternating current and using a properly installed socket outlet with earthing contact. The mains voltage must correspond to the voltage specification on the washing machine (nameplate). Connection specifications as well as the required fuses are stipulated on the appliance nameplate.
- Page 30 All manuals and user guides at all-guides.com Before transporting the washing machine: Transport, - Turn off the water tap, e.g. when moving - Drain any residual washing solution (refer to Page 16), - Release the water pressure in the supply hose (refer to Page 17), - Disconnect the washing machine from the mains.
- Page 31 All manuals and user guides at all-guides.com...
- Page 32 All manuals and user guides at all-guides.com Printed in Germany PW/ED1-M 1200 en 5550 005 238 ROBERT BOSCH HAUSGERÄTE GMBH...