Table of Contents
Advertisement
9. GRILLE INSTALLATION
1. INSTALLING BLOWER COVER INSULATION (IN CASE OF 2 OR 3 OUTLET DIRECTION)
• Install the blower cover insulation only when the outlet direction
is changed to 2 or 3 direction.
• Two blower cover insulations are packed with the grille assem-
bly.
• Install the blower cover insulation at the diffuser position shown
in Fig. 13. At this time, use pipe side as the criteria.
• Do not install the blower cover insulation at the diffuser position on pipe side.
• Do not set the 2-way outlet as shown in the figure to the right. Setting in this
manner will cause performance problems.
2. INSTALLING GRILLE ASSEMBLY TO BODY
Hang the grille assembly on the wires attached to the indoor unit as shown in Fig. 14.
Fig. 14
Wire
Wire hook
Motor cover assembly
En-10
CAUTION
Wire
hook
Wire
Wire hook
Fig. 13
Example
3 direction
Do not
install here.
Pipe side
Fit the blower cover
insulation.
Main
body
Blower cover
A-A Section view
insulation
Pipe
Pipe
Pipe side
Advertisement
Table of Contents
