Table of Contents
Advertisement
Installing the grille assembly to the body
Install the grille assembly to the body with the four bolts and washers.
(1) Lightly tighten the bolts shown in "B" of Fig. 15. Hang the panel.
(2) Tighten the other bolts.
(3) Tighten all bolts securely.
(4) Connect the connector in accordance with part A detail view. (Fig. 16)
Fig. 15
3. INSTALLING/REMOVING THE INTAKE GRILLE
INSTALLING THE INTAKE GRILLE
(1) Fully insert the intake grille hooks into the rectangular holes in the panel. (Fig. 17)
(2) Close the intake grille, then slide the two grille stoppers outward. (Fig. 18)
Fig. 17
Fig. 16
A
Washer
Bolt
B
No gap between ceiling and
grille around entire periphery.
Fig. 18
Panel
Rectangular hole
Grille hook
Intake grille
Part A detail view
Joint wire
(Louver)
Display PCB
wire harness
Grille stopper
Wire (Louver)
Display PCB wire harness
En-11
Advertisement
Table of Contents
