Maxi-Cosi Mico Max 30 Instructions Manual page 29

Unbuckle the belt.
NOTE: If the latch plate ends up just at the belt
path opening so you cannot grasp the vehicle belt at
the latch plate, grasp the vehicle belts on the opposite
side of the child restraint, as close to the latch plate as
possible.
53
1. Determine Locking Clip
Location
Grasp both vehicle belts
together just behind the
latch plate to mark the
position for locking clip.
2. Attach Locking Clip
Thread both portions of the
vehicle belt onto the locking
clip, as close to the latch
plate as possible.
3. Position Locking Clip
Position locking clip about
1 in. (2.5 cm) from vehicle
belt's latch plate.
4.
5.
6.
Remove the locking clip when the vehicle seat
belt is not being used with a child restraint.
Rebuckle Vehicle Belt
Check Vehicle Belt
Tightness
Hold base or child restraint
at the belt path with your
weakest hand.
Push and pull from side to
side.
If it moves more than 1 in.
(2.5 cm), try reinstalling the
child restraint or try another
seating location.
Recheck Level Line
The level line on shell
MUST be parallel with the
ground.
54