Adjustment Procedure; Color Registration; Line Position Adjustment; Adjustment For Line Speed Of Fusing Unit - Gestetner G060 Service Manual

Adjustment Procedure

1. Enter SP mode and access SP5-997.
2. Print out the pattern (14: 1-dot trimming pattern) with SP5-997.
NOTE: Registration may change slightly print by print as shown above.
Therefore print a few pages of the trimming pattern for step 3 and 4.
Average the leading edge and side-to-side registration values and
adjust each SP mode accordingly.
3. Perform the leading edge registration adjustment.
1) Check the leading edge registration and adjust it with SP1-001.
2) Select the adjustment conditions (paper type and process line speed).
3) Input the value then press the [Escape] key.
4) Check the leading edge adjustment by generating the trim pattern.
4. Perform the side to side registration adjustment.
1) Check the side to side registration and adjust it with SP1-002.
2) Select the adjustment conditions (paper feed station).
3) Input the value then press the [Escape] key.
4) Check the side to side adjustment by generating the trim pattern.

3.2.2 COLOR REGISTRATION

Line Position Adjustment

Normally, the automatic line position adjustment is executed under a specified
condition to optimize the color prints. If a color registration shifts, execute "Auto
Adjust" with the user tools (Maintenance menu - Color registration) or SP5-993-2
to do the forced line position adjustment. In addition, it is recommended to perform
the line position adjustment under the following conditions:
• After transporting or moving the printer (if printers are pre-installed at the
workshop and transported to the user location, forced line position adjustment
should be done after printer installation is completed at the user location.)
• When opening the drum positioning plate
• When removing or replacing the motors, clutches, and/or gears related to the
drum/development/transfer sections
• When removing or replacing the transfer belt or laser optical housing unit

Adjustment for Line Speed of Fusing Unit

Optimize the line speed for the fusing unit when the color registration shifts more
on the trailing edge compared with that on the leading edge, even after line
position adjustment is executed. Adjust the speed of development motor-K with the
following user tool in the Maintenance menu.
"Menu/Maintenance/Color Regist./Fuser Adjust/Custom Adjust"
Refer to Maintenance Guide 1 of the Operating Instructions for how to adjust this.
SM 3-3
IMAGE ADJUSTMENT
G060