Machine Installation - Gestetner G060 Service Manual

1.4 MACHINE INSTALLATION

Refer to the Operating Instructions for details.
If the customer has a service contract, change the settings of the following SP
modes depending on the contract type.
Item
Meter charge SP5-930-1
Counting method SP5-045-1
A3/11" x 17"
SP5-104-1
double counting
PM warning SP5-930-3
display 1
PM warning SP5-930-4
display 2
SP5-930-5
Fax No. setting SP5-812-2
SM
SP No.
Specifies whether the meter charge
mode is enabled or disabled.
Meter charge mode enabled:
• The Counter menu appears
immediately after the Menu key is
pressed.
• The counter type selected by the
counting method (SP5-045-1) can be
displayed with the Counter menu.
• The counter values can also be
printed with the Counter menu.
• The selected counter starts from a
negative number.
Meter charge mode disabled:
• The Counter menu is not displayed.
• The total counter starts from 0.
Specifies whether the counting
method used in meter charge mode is
based on developments or prints.
Important:
This SP can only be done before the
negative counters are reset with SP7-
825-001
Specifies whether the counter is
doubled for A3/11" x 17" paper.
Specifies whether the PM warning for
PCUs and development units is
displayed when the replacement time
arrives.
Type 1: Displayed
Type 2: Not displayed
Specifies whether the PM warning for
to the paper feed roller and transfer unit
is displayed.
Programs the service station fax
number.
The number is printed on the counter
list when the meter charge mode is
selected, so that the user can fax the
counter data to the service station.
1-5
MACHINE INSTALLATION
Function Default
Off
Developments
No: Single
counting
Type 1
Off:
G060