Switching On The Instrument; Setting The Time - Leica TP1020 Instructions For Use Manual

4.4

Switching on the instrument

4.5

Setting the time

0 1
Leica TP1020
• Turn on the instrument with the power switch
on the right side at the rear of the instrument.
The instrument does a startup run.
Next, the instrument name and software version
(e.g. V 1.00) are displayed.
This reading disappears after about 10 seconds.
Next, the number of the processing station where
the basket holder is located and the real time
indication are displayed.
• Press "CLOCK".
The cursor blinks at the hour indication.
• To adjust the hours, press PLUS or MINUS
respectively.
• Press ARROW RIGHT.
The cursor jumps to the minute indication.
8
• To adjust the minutes, press PLUS or MINUS
respectively.
• To finish setting the time press CLOCK again.
4. Instrument Setup
33