Table of Contents
Advertisement
CMBS Indicator
U.S. model is shown.
This indicator comes on for several
seconds when you select the ON
mode by operating the engine start/
stop button (see page 194). It also
comes on and stays on when you
turn the CMBS off by pressing the
CMBS OFF button.
To turn the CMBS back on, make
sure the vehicle is stopped and the
power mode is set to ON, then press
the CMBS OFF switch for about 1
second.
The CMBS indicator normally comes
on under these conditions:
When you manually turn off the
●
system.
When the system shuts off
●
automatically.
When you drive in bad weather
●
(rain, snow, fog, etc.).
If anything covers the radar sensor
●
CMBS
cover (dirt, mud, dry leaves, wet
INDICATOR
snow, etc.).
When the VSA system indicator
●
comes on (see page 508).
Collision Mitigation Braking System™ (CMBS™)
2010 ZDX
When you select the ON mode by
●
operating the engine start/stop
button, the CMBS indicator should
come on for a few seconds, then
go off. If the indicator comes on at
any other time and a CHECK
CMBS SYSTEM message appears
on the multi-information display,
there is a problem with the CMBS.
You can still drive your vehicle,
but CMBS will not be operating.
Have your vehicle checked by a
dealer.
CONTINUED
503
Advertisement
Table of Contents
