How The Srs Indicator Works - Acura 2010 ZDX Owner's Manual

Hide thumbs Also See for 2010 ZDX:
Table of Contents

Advertisement

Additional Information About Your Airbags
In a Rollover
If the SRS control unit senses that
your vehicle is about to rollover, it
immediately deploys both side
curtain airbags and activates both
front seat belt tensioners.
The airbag on the passenger's side
will deploy, and the seat belt
tensioner will activate, even if there
are no passengers on that side of the
vehicle.
To get the best protection from the
side curtain airbags, occupants
should wear their seat belts and sit
upright and well back in their seats.
34

How the SRS Indicator Works

The SRS indicator alerts
you to a potential problem
with your airbag system components.
When you turn the ignition switch
to the ON (II) position, this indicator
comes on briefly then goes off. This
tells you the system is working
properly.
ꭧ: Models equipped with the
keyless access system have an
engine start/stop button instead of
an ignition switch. ON mode is the
equivalent of ON (II). For more
information, see pages
194
2010 ZDX
If the indicator comes on at any other
time, or does not come on at all, you
should have the system checked by
your dealer. For example:
If the SRS indicator does not come
on after you turn the ignition
switch to the ON (II) position.
If the indicator stays on after the
engine starts.
If the indicator comes on or flashes
on and off while you drive.
You will also see a ''CHECK AIRBAG
SYSTEM'' message on the multi-
information display (see page 90).
and 196.
If you see any of these indications,
the airbag system components may
not work properly when you need
them.

Advertisement

Table of Contents
loading

Table of Contents