Table of Contents
Advertisement
MODE － To switch between the
category mode and channel mode,
push the interface selector down to
display AUDIO MENU, then turn the
interface dial to select Mode, and
press ENTER on the interface
selector.
Turn the interface dial to select CH
or CAT, then press ENTER on the
interface selector. Move the interface
selector up to go back.
You can also switch the mode by
pressing the TITLE side of the
SCAN/TITLE bar for 3 seconds.
In the category mode, such as Jazz,
Rock, Classical, etc., you can
navigate through all of the channels
within that category. In the channel
mode, you can select all of the
available channels.
Playing the XM
®
Each time you press and release the
TITLE side of the bar, the display
changes in the following sequence:
CATEGORY NAME, NAME (artist
name), TITLE (music title), and
CHANNEL NAME (channel name).
On the screen, you will see the
selected CHANNEL (number),
CATEGORY, NAME (artist name),
and TITLE (music title).
You may experience periods when
XM Radio does not transmit the
artist's name and song title
information. If this happens, there is
nothing wrong with your system.
TUNE － Press either side of the
TUNE bar to change channel
selections. Press the
side of the
bar for higher numbered channels
and the
side for lower numbered
channels. You can also change
channels with the interface selector.
2010 ZDX
Radio (Models with navigation system)
Push it down to select AUDIO
MENU. Then turn the interface dial
to select TUNE and press ENTER on
the interface selector. Turn the
interface dial to exit the tune mode
and press ENTER on the interface
dial.
CHANNEL LIST － Push down the
interface selector to select AUDIO
MENU, then turn the interface dial
to select Channel List and press
ENTER on the selector. Turn the
interface dial to select a channel,
then press ENTER to set your
selection.
CATEGORY (－ or ＋) － Press
either side of the bar to select
another category.
CONTINUED
293
Advertisement
Table of Contents
