Yamaha DCD1+PS Operation Manual page 40

8
Use [<] and [>] to select an
option, then press [ENTER].
The re-recording is saved as indicated or
canceled.
Note: It is also possible to re-record the
Ensemble parts.
See "Recording Ensemble Tracks" in your
piano's manual.
When Re-recording Using a
Different Song on the Same
CD
1
Specify the CD that is to be
recorded.
When you insert CD into the CD drive, the
letter "Cd" automatically appear on the left
side of the display.
2
Specify a disk.
Note: If you are recording to a floppy disk,
make sure that the disk's erasure
protection tab is set to "unprotected".
Unformatted disks must be formatted before
use with the Disklavier. See "Formatting
Disks" in your piano's manual.
3
Press [REC] to engage the Record
Standby mode.
The REC indicator lights and the
PLAY/PAUSE indicator flashes.
A new song number is created for the new
recording. For example, if the last song to
be recorded was No.6, then the new song
will be No.7.
4a
Press [REC] until CD song
recording setting screen appears.
The following display appears.
34
4b
Use the [–/NO] and [+/YES]
buttons to select the number of
the song on the CD to be played.
The following display appears.
4c
To end now, press [STOP], and
proceed to step 6.
5
To re-record, press [PLAY/PAUSE],
and recording will begin.
Start playing your song with the CD sound.
The following display appears.
6
When you finish playing your
song, press [STOP].
When [STOP] is pressed, the following
display appears.
The following table gives a description of
each of options.
Option Description
SAVE The new recording is saved
under the current song number.
"PS" indicates PianoSmart.