Repeat Play; Adjusting The Volume - Yamaha DCD1+PS Operation Manual

Repeat Play

You can listen to a CD repeatedly by simply
pressing [REPEAT].
Press [REPEAT] during playback.
REPEAT
or
The REPEAT indicator lights.
After the last song on the CD is played, the
entire CD is played back again
automatically.
Pressing [REPEAT] again cancels Repeat
mode.
REPEAT

Adjusting the Volume

You can adjust the playback volume using the
VOLUME knob.
For songs on PianoSoft . PlusAudio, set VOLUME
to 0 and set BALANCE to MIN. Then gradually
raise the BALANCE until a desired volume is
achieved.
See "Balancing the Audio Parts" below.
To raise the volume,
turn the knob clockwise.
•
VOLUME
•
•
•
–10 •
To lower the volume,
turn the knob counterclockwise.
•
VOLUME
•
•
•
–10
•
Turning the knob fully counterclockwise
mutes the sound completely.
Note: With pianos whose Piano Type is Disklavier or
GT10, and with Disklavier pianos with a
Control Unit, it is recommended to play back
CDs at level "0". Lowering the volume may
cause some distortion in the sound.
Note: With the MX100B piano, playing a CD with
the piano volume in "soft" mode may cause an
error in the timing of the piano sound output,
so that the piano parts and audio parts are not
synchronous. It is recommended to play back
CDs with the piano volume raised to a
standard audible level.
•
•
•
•
•
• 0
•
•
•
•
•
0
•
27