Table of Contents
Advertisement
Chapter 6
Synchronization Using the MTC
This function is available only on Disklavier models with recording function.
Synchronization Using
the MTC
Upgrading the version of your controller allows
you to use the MTC (MIDI time code)
synchronization function. This function can only
be used in controllers with a recording function.
MTC Synchronization
Settings
In order to achieve synchronization using the
MTC, the settings for sending and receiving the
MTC are performed.
This Disklavier has a function that uses the MIDI
time code (MTC) to synchronize with an external
component.
This Disklavier can function either as the Master
or as the Slave when synchronization is to be
achieved using the MTC. Set the MTC-related
parameters in order to use the synchronization
function.
1
Press [FUNC.].
The FUNC. indicator lights and the
Function menu appears.
2
Press [ > ] until the c cursor is next
to the MIDI setup option, then
press [ENTER].
The following display appears.
3
Press [ > ] until the c cursor is next
to the MTC, then press [ENTER].
The following display appears.
One of the following three MTC mode
parameters can be selected.
OFF:
The synchronization function is
(default) set to OFF.
Slave:
Disklavier operates in response to
the MTC received from the
external component.
Master: Disklavier sends the MTC to the
external component.
Note: The MTC settings are stored in the
memory when the power is turned off.
Depending on the MTC settings, some
restrictions apply to the remote function.
See "Correlation between MTC Settings and
Remote Function, and Behavior" on page
42.
37
Advertisement
Table of Contents
