Table of Contents
Advertisement
1
Technical Data
Hydraulic plate puncher HS-8
Punching power
Cutting material
Lift
Manual exertion
Lever transmission
Length
Weight
Oil specification
2
Safety Instructions
Attention: Before using the tool please read all safety instructions. Always keep
these safety instructions together with the tool and ensure the instructions are
heeded at all times. HAUPA cannot legally be held responsible for any damage or
injury sustained which is related to incorrect usage of the tool or as a result of poor
maintenance. Should there be any further questions regarding use of the product or
any aspect safety measures, please contact HAUPA.
1. Keep your workplace clean and free from foreign bodies and always take care
that there is sufficient lighting.
2. Always wear protective clothes and spectacles.
3. Make sure that the tool is protected from external damage e.g. the effects of
excessive heat, open fires, sharp edges, moving pieces of machinery,
corrosive chemicals and damp.
4. Avoid high pressure on the tool! Use the cutter only according to technical
data regarding cutting material and cutting capacity.
5. Do not try to extend the handles beyond their normal length!
6. Only allow authorized personnel to carry out repair and maintenance work to
the tool. Any maintenance / repair work carried out by unauthorized personnel
will invalidate the guarantee.
7. Make sure that the matrix is concordant with the cutting edge concerning the
diameter.
Approx. 80 kN
Steel plates up to max. 3 mm strength
22 mm
Approx. 350 N
1:10
308 mm
2,4 kg
Hydraulic oil GW ISO 7
Use only water and acid free oil!!!
2
Advertisement
Table of Contents
