Table of Contents
Advertisement
1. Technical data
Area of application: For the creation of an electrical connection by means of compression
Scope of delivery:
Pressing force:
Oil type:
Feed rate:
Safety:
Structure:
Guarantee:
2. Area of work
• Pressing force in kN: 120 kN
• Working pressure in bar: 700
• Opening/ Hub: 20 mm
• Pressing width: width
• Motorstop
• H-head „Deep Indent Pressing": Cu/Al Tube Cable lugs and connectors
• Crimping range cable lugs: Cu 10-400 / DIN Cu 10-300 / DIN Al 16-240
• Crimping range connectors: Cu 10-400 / DIN Cu 10-300 / DIN Al 16-240
• Pressing time, battery-operated in seconds: 6-12
• Battery charging time in minutes: 120
• Battery type: Li-Ion, 18 V, 4 Ah
• Dual-piston pump
• Weight in kg: 7
• Weight of set in kg: 12
2.1. Sensortechnology
With the different colours of the sensor LED, it shows whether the pressing has
been completed successfully or which errors have occurred:
Light is green: Pressing completed as standard, motor stopped
Light is orange: Battery voltage not sufficient
Light is red: Pressing interrupted before completed
The device also has 2 white LED designed to illuminate the working area.
1 crimping tool, 1 charger, 1 battery, 1 carry strap, in a plastic case,
without dies.
120 kN
ISO class viscosity 15
2 speeds: Closing (fast) feed to bring the pressing dies to the conductor
and working feed for compression. Switching between the two speeds is
carried out automatically.
The tool is fitted with a safety value that has been set at the factory.
The working head can be rotated by 180° to make it easier to adapt to
the operation to be carried out. The hydraulic crimping tool does not
protect the operator when working on cables that carry power.
2 year guarantee if used for the purpose it is intended.
Advertisement
Table of Contents
