Bitstorm 2600 Startup Procedure; Login; Management Modes - Paradyne IP DSLAM BitStorm 2600 Installation Manual

4. Configuration

BitStorm 2600 Startup Procedure

Login

Management Modes

4-4
You can initialize your BitStorm 2600 via a PC or terminal connected to the unit's
CONSOLE port. Then, using a series of CLI commands, GrandVIEW EMS or
another Element Management System, or the web interface, you can configure the
unit according to your requirements.
Procedure
To log in to the BitStorm 2600:
1. Connect a PC or terminal to the CONSOLE port. (See
Chapter 2, Cabling.)
2. At the login> prompt, type admin and press Enter.
3. At the password> prompt, press Enter. The default login password is blank.
4. At the PDYN> prompt, type privilege and press Enter.
5. At the password# prompt, press Enter. The default privileged password is
blank.
You are now logged on and in privileged mode, which allows you to configure the
unit.
The startup procedure for the BitStorm 2600 system differs depending on the type
of management used:
Inband Management – Operates over the uplink.
Out-of-Band Management – Operates over Port 1.
March 2005
Console Port in
2600-A2-GN20-40