32-Ch 2-Bay -Nvd With Dual Display (Svd-832); System Overview; Led & Buttons Definitions - Seenergy svr-204 Quick Manual

50 Standalone NVRs & NVD Quick Guide

32-Ch 2-bay -NVD with Dual Display (SVD-832)

System Overview

LED & Buttons Definitions
LEDs Status
Network Green
Amber
Status Green
Red
Amber
Power Green
Red
Amber
Alarm Red
None
Buttons
Power btn ON
OFF
Reset Restore default
Restart
Buzzer stop STOP
Buzzer
Beep Complete start
Initiating restart
Initiating shutdown Beep once (Indicating users to release the Power button as the shutdown process has begun)
Definitions
Solid green for activity on a 10/100Mbps network
Solid amber for activity on a 1Gbps network
*Shows solid green for normal operation
*Blinking green when firmware upgrade is done
Blinking red for failed firmware upgrade through USB disk
Blinking amber during firmware upgrade
*Solid green - Normal operation
*Slow blinking in green after press and hold the reset button for 5 seconds indicates the device will enter
the restore default process. Other LEDs remain unchanged during this state.
System off (power cord remains plugged in)
*Fast blinking in amber during system initializing/starting. Continous blinking when system is unable to
start properly (All other LEDs should be off when this LED is blinking in amber)
* Slow blinking indicating the system is shutting down. Other LEDs go off according the stage of the
process.
Blinking in red when a system/camera event occurs. Blinking should last 10 seconds for each event
Goes off if reaches the 10-second duration, or when buzzer stop button is pressed (if buzzer is triggered)
Press and hold for 2 seconds
Press and hold for 2 seconds
Press and hold for 5 seconds
Press and hold for 2 seconds
Press and release should stop buzzer right away
Beep once (indicating the system is fully started)
Beep once (Indicating the restart process has begun)