Standalone NVR Quick Guide HDD Installation 1.Remove the screws on back side. Remove the top case by pulling it toward you.
Page 5
Standalone NVR Quick Guide 2. Install HDD on brackets with screws Prepare HDD brackets. Fix the HDD on bracket with screws You can install two HDDs with brackets.
Page 6
Standalone NVR Quick Guide 3.Install SATA Cable Prepare SATA cable. Install SATA cables on system, install SATA data cable. Install power cable. Install SATA cable on the HDD.
Page 7
Standalone NVR Quick Guide 4. Install HDD brackets Fix HDD brackets on system with screws.
Standalone NVR Quick Guide Connect to the NVR There are various ways you can connect to the NVR and below are the suggested methods for different network setup: • The NVR is placed in a network with a DHCP server: Connect to the NVR by using “Device Search”...
Page 9
Standalone NVR Quick Guide To begin, launch the “Device Search” utility from the CD and proceed with the installation: Once the installation is complete, check the “Launch the Search AP” option and click “Finish”.
Page 10
Standalone NVR Quick Guide The search should start automatically and its status should be dis- played. The NVR should be located and its IP address should be displayed. Double-click on an NVR and the search program should automatically access the NVR’s web administration page from your default browser.
Standalone NVR Quick Guide You should be prompted for the NVR’s username and password. Enter its default username “admin” and password “admin” and then click ”OK” to enter the system Access the NVR with its default IP address The NVR comes with a pre-configured static IP “192.168.101.50”. However, it is only used when there is no DHCP server presented in the network.
Standalone NVR Quick Guide The PC that is connected directly to the NVR (or within the same local area network) should receive an IP from the NVR. Simply access the NVR from your web browser with its IP address Again, you should be prompted for the username and password. Enter its default username “admin”...
Page 13
Standalone NVR Quick Guide The default login username and password is admin/admin. To change the password of the admin account, go to “Setup” --> “System Con- figurations” --> “User Account”, click on the “admin” account in the account list then press the “edit” button to change its password.
Standalone NVR Quick Guide Camera Installation Add a Camera -- Automatic Search Click the “Search” button to perform the camera search. You should be prompted to install Active Control component in order for the search to function properly. Go ahead and click “Install” After that, the search should begin and its status should be displayed:...
Page 15
Standalone NVR Quick Guide Found cameras should be listed and simply select a camera from the list and press “Configure” Its corresponding information should be displayed in the “Camera Information” section. Enter its username and password and select the channel ID and name the camera.
Page 16
Standalone NVR Quick Guide Click on “Detect” to establish connection between the recorder and the camera. If connection establishes successfully, camera’s detailed information should be polled and displayed as below. Adjust its video format, frame rate, resolution or bitrate...etc if you wish and then click “Add”...