Printer Checkout; Set The Power Switch To On - IBM 5256 User And Setup Manual

2-4
PRINTER CHECKOUT
The following procedure ensures that the 5256 Printer is properly set up and
communicating with a 5251 Display Station Model 2 or 12, a System/34, or a
System/38. Before doing this procedure, make sure that the cable that
attaches to the 5251 Display Station Model 2 or 12, System /34, or System /38
is plugged in and that it is powered up. After doing this procedure, proceed to
Cable Thru Feature.
If you have any problems while doing this checkout procedure, refer to the
Problem Checklist on the last two pages of this section.
1. Make sure the Status switch is set to Normal.
4 5
O
Storage
0
Internal
Check Check
o
Attention
o
Forms
O
Unit
Check
Line
Spacing
D:
2. Set the Power switch to On.
8
O
Transparent
Mode
Status
8
Cancel
Normal
Test
After approximately five seconds, the Power On, Line Sync, and System
Available lights should be the only lights on.
Power
.on
DOff
•
Power
On
Stop
D
3. Press Start.
o
Ready
•
Line
Sync
Line
Start Feed
D
D
2
•
System
Available
Form
Feed
D
The Ready light also turns on now and the print head moves into position
to start printing.
2
• Power
On
• Ready
• Line
Sync
• System
Available
Line Form
Power
Stop
Start
Feed Feed
~on
Off
B ~
D D